C0v2 Aero Coat

	Aero Coat v2 30ml Quantity	$99.00
	Aero Coat v2 50ml Quantity	$154.00

MSDS	Take a look at the Material Safety Data Sheet for C0 Aerocoat v2
Application Information	Storage and use Shake well before use and apply out of direct sunlight Wear gloves Dab the product onto the AP2 Ultra Soft Foam Filled Microfibre Applicator Pad provided Replace the lid on the bottle and set aside- as holding in your hand can promote premature curing Apply product to a large size panel, or several smaller panels Leave for 2-3 minutes and remove residue with an MF1 ZeroR Microfibre Buff Cloth, then conduct a second buff with an MF6 Haze Buster or another MF1 Make sure that all cloths used are rotated quickly so that the coating does not partially cure in the cloth If you miss removing residue and it cures fully, it will need to be re-polished and the the coating reapplied to the area As soon as you finish put the microfibres in water, wash and dry them as soon as possible - if not the product will crystallise on the cloth Allow the coating to cure for 12 hours, before exposing the car to the elements Store in a cool, dry place Use within 3 months of opening
Width in cm.	No

Why use Gtechniq C0v2 Aero Coat?

C0 has been formulated to minimise adhesion of foreign objects on race cars. However, it can also be used on road cars with a lifespan of up to 2 years.

It offers great gloss, good hydrophobicity (110 degrees), some swirl resistance (6h) and can be applied to paint and gel coat.

Please note: compared to our other coatings it C0 Aero Coat is relatively hard to apply. The product is quite viscous and requires considerably more effort when removing residue - we recommend you will need at least 10 MF1 ZeroR Microfibre Buff Cloths to carry out one application.

C0 can be applied as a stand-alone product or top coat for other Gtechniq permanent paint protections.

Take a look at the Material Safety Data Sheet for C0 Aerocoat v2

Storage and use

Shake well before use and apply out of direct sunlight

Wear gloves

Dab the product onto the AP2 Ultra Soft Foam Filled Microfibre Applicator Pad provided

Replace the lid on the bottle and set aside- as holding in your hand can promote premature curing

Apply product to a large size panel, or several smaller panels

Leave for 2-3 minutes and remove residue with an MF1 ZeroR Microfibre Buff Cloth, then conduct a second buff with an MF6 Haze Buster or another MF1

Make sure that all cloths used are rotated quickly so that the coating does not partially cure in the cloth

If you miss removing residue and it cures fully, it will need to be re-polished and the the coating reapplied to the area

As soon as you finish put the microfibres in water, wash and dry them as soon as possible - if not the product will crystallise on the cloth

Allow the coating to cure for 12 hours, before exposing the car to the elements

Store in a cool, dry place

Use within 3 months of opening

More Views

Additional Information